Rollformline – Agcor Steel

Rollform Line Maintenance Checklist Weekly: 30 Minutes

First Name

Last Name

Date / Time

Checkbox Field

Visually check all toolings clearance with mirror. Make sure gap appears correct across entire station. Check with feeler gauge if a gap appears incorrect.

Visually check tooling and any moving parts for signs of wear.

Run and jog machine empty and listen for any unusual noises and pinpoint cause.

Visually inspect under, in, and around machine for any sign of wear(material accumulation e.g. Paint dust, metal shavings, rubber dust, oil, loose screws, etc.)

Physically check bolts on uncoiler arms.

Check for adequate tension on drive chains (Rollformer & Uncoiler)

Comments/Notes

Rollform Line Maintenance Checklist Monthly: 2 Hours

First Name

Last Name

Date / Time

Monthly

Physically check sprocket set screws-Power down, lock out, remove guard panels, remove motor chain(s), rotate shafts and tighten all loose set screws. Apply BLUE locktite as needed.

Physically check clearance gaps between top and bottom dies and make adjustments as needed.

Visually check sprockets for unusual wear.

Physically check for other loose bolts, nuts, and screws.

Grease Chains.

Comments/Notes

Rollform Line Maintenance Checklist 6 Months: Ag Panel, 1 Hour

First Name

Last Name

Date / Time

6 Months

Grease bearings-Only 1 to 2 pumps of grease to zerks located on each bearing.

Comments/Notes

Rollform Line Maintenance Checklist Yearly: R-Panel, 1 Hour

First Name

Last Name

Date / Time

Yearly

Grease bearings-Only 1 to 2 pumps of grease to zerks located on each bearing.

Comments/Notes